Unbox your Walkabout Pouch (WP) and lay it out on a flat surface (See photo.) Ensure the top (2) clips are closed, and the (2) side clips are open.

Put the pouch on by pulling both shoulder straps over your head, allowing the front panel to rest against your torso. (This may seem similar to wearing a baby harness or a backpack on your chest.)

With the front panel open, you can safely access your device as well as any items stored in the interior pocket. To store your device, simply bring the front panel back to your torso and close the (2) top clips.

Flip the pouch over so the front panel is facing down. Remove the included Velcro strips with adhesive backing from the inner pocket of the WP. 

Locate the (2) unfastened clips on each shoulder strap and fasten them to the clips on each side of the pouch. Adjust the side straps as needed to ensure a secure fit. Then use your Strap ties to hold any excess strap length. 

When adjusting the side straps, you may find you have an extra length of strap webbing loose at the ends. ​If so, secure it with the attached Strap Tie, shown here.

Apply the adhesive backing of the included Velcro strip to the back-side of your device or device case. (Use one or both strips.)

Unclip the (2) top clips to release the front panel. Securely attach your device by affixing the Velcro strip on the back of your device or device case to the Velcro on the interior of the front panel. 

Check out our instructional videos below to learn how to wear and adjust your pouch.

If you need additional assistance, check out our videos below feel free to reach out.